Metrohydraulic - Norco Products - Rolling Lift Bridge

MODEL 79324C
2-1/2 TON CAPACITY
AIR/HYDRAULIC PUMP
INTENDED USE
For use in conjunction with above ground lifts. The Rolling Lift Bridge straddles the lift rails for wheel alignment, brake, tire and suspension work.

FEATURES
Push button air/hydraulic pump provides safe, quick lifting. Adjustable arms and lifting pads safely support the vehicle on the bridge. Adjustable hook-end or flat-end mounting brackets enable the bridge to be mounted on most lifts. Hook-end mounting brackets are standard equipment with both model bridges. All mounting brackets are equipped with spring loaded roller bearings for smooth maneuverability of bridge on lift rails. Mechanical stop prevents accidental lowering of bridge. Lowering is accomplished with one hand on the release lever and the other hand releasing the mechanical stop. Equipped with rubber faced saddle for differential lifting.

NOTE:
Some mounting brackets may require an offset if the rolling lift bridge bottoms out before the above ground lift. If the above ground lift is 1" from bottoming out, it will be necessary to order a 1-1/2" offset on the mounting brackets. Offset brackets are available at no extra charge. Determine the amount of offset and type brackets (flat-end or hook-end) required before placing an order.

OPTIONAL EQUIPMENT

MODEL 79328A 9" EXTENSION ADAPTERS For use with light duty trucks, vans and 4x4's. The adapter increases the "1" dimension on the specification chart from 2" to 9". Weight: 19 lbs.
MODEL 79326 FLAT-END MOUNTING BRACKETS Flat-end mounting brackets enable the Rolling Lift Bridges to roll on flat surfaces. Weight: 30 lbs.
MODEL 79327 HOOK-END MOUNTING BRACKETS Hook-end mounting brackets enable the Rolling Lift Bridges to roll on the rails of the lift. Weight: 26 lbs.